Samsung AM***MNVD Series - Page 28

Setting an indoor unit address and installation option
Indication 0 2 3 4 5 6 7 8 9 A #
Stopped
6OJUhT&&7TUFQ
Default 90 ↔ 160 100 ↔ 160 110 ↔ 160 120 ↔ 160 130 ↔ 160 160 200 250 300 400
(*5) When the following 2 or 3 is used as external heater On/Off signal, the signal for monitoring external contact control will not be output.
2: Fan is turned on continually when the external heater is turned on,
3: Fan is turned off when the external heater is turned on with cooling only indoor unit
Cooling only indoor unit: To use this option,install the Mode Select switch(MCM-C200) on the outdoor unit and fix it as cool mod.·
t *G'BOJTTFUUPPGGGPSDPPMJOHPOMZJOEPPSVOJUCZTFUUJOHUIF4&(PS4&(ZPVOFFEUPVTFBOFYUFSOBMTFOTPSPSXJSFESFNPUF
controller sensor to detect indoor temperature exactly.
(*6) When indoor unit is in cooling or Dry mode, The output signal is "ON".
'PSGSFFDPPMJOHDPOUSPM&DPOPNJ[FSDPOUSPMMFSJTSFRVJSFE
Do not install the electronic heater
in the flow channel of the indoor unit fan.
Air Flow
Suction side Discharge side
Electronic heater should
not be installed.
Duct Indoor unit
05 series installation option
4&( 4&( 4&( 4&( 4&( 4&(
05
Use of Auto Change Over or
cooling only for HR only
8IFOTFUUJOH4&(
Standard heating temp.
0òTFU
8IFOTFUUJOH4&(
Standard cooling temp.
0òTFU
8IFOTFUUJOH4&(4UBOEBSE
for mode change Heating
→
Cooling
4&( 4&( 4&( 4&( 4&( 4&(
1
8IFOTFUUJOH4&(4UBOEBSE
for mode change Cooling
→Heating
8IFOTFUUJOH4&(5JNF
required for mode change
Compensation option
GPS-POHQJQFPSIFJHIU
EJòFSFODFCFUXFFO
indoor units
MTFC (*3) -
4&( 4&( 4&( 4&( 4&( 4&(
2- - - -
Control variables when using
hot water / external heater (*4)
4&( 4&( 4&( 4&( 4&( 4&(
3- - -
Forced FAN Operation
for Heating and
Cooling
-
English-28