Disassembly and Reassembly
Samsung Electronics 311
No Parts
Procedure Remark
2 CONTROL-IN
7) Unfasten a screw of the Ground wire and pick
up Temperature wires from ASSY EVAP.
(Use (+) Screw Driver.)
8) The CONTROL-IN is fixed to HOLER PIPE by a
hook bottom of the case as shown in the last
figure. (Please loosen remaining connectors
before detaching CASECONTROL.
Caution:
When you separate the connector, pull pressing
the locking button
9) Put down of the HOLDER PIPE and push up
the hook and lean side the case as shown in
figures.
To Next Page
Loading...