Disassembly and Reassembly
348 Samsung Electronics
No Parts Procedure Remark
1 Control Part 1) Remove the 3 fixed screws to remove the
Control-Box Cover. (Use +Screw Driver)
2) Disconnect the Connector Wire that is con-
nected to the indoor unit’s PBA.
3) Unscrew the 2 fixed screws on both sides
of the Control Box, and disassemble the
Control Box from the indoor unit.
(Use +Screw Driver)
2 Drain Pan 1) Unscrew the screws on the 4 corners of the
indoor unit. (Use +Screw Driver)
2) Remove the Drain Pan from the indoor unit.
■ 4Way Cassette type(600x600)
To Next Page
Loading...