Disassembly and Reassembly
Samsung Electronics 313
No Parts
Procedure Remark
4 EVAPORATOR
(Continues)
1) The HOLDER PIPE is fixed to body by 2
hooks as shown in the figure.
2) To detach the HOLDER PIPE from the main
frame,loosen 2 hook structhres.
When separate hooks: Use the (-) Screw
Driver. Insert the (-) Screw Driver into the
gap of the hook and lean to the Moter side
as shown in figures. (Watch out for the
damate of hooks)
3) Remove the HOLDER PIPE.
4) Unfasten a screw of the Fan Moter side.
(Use (+) Screw Driver.)
5) Unfasten 2 screws of the opposite side of
the Fan Moter. (Use (+) Screw Driver.)
To Next Page
Loading...