Samsung AM280FNHDEH/EU - Page 26

26_ installing your air conditioner
(*5)
This function can be applied to 4 Way Cassette and Mini 4 Way Cassette only. If the air conditioner operates the heating mode immediately after
nishing the cooling mode, the condensated water in the drain pan becomes water vapor by the heat of the indoor unit heat exchanger. Since the
water vapor might be condensed on the indoor unit, which may fall into a living space, use this function to get rid of the water vapor out of the
indoor unit by operating the fan (for maximum 20 minutes) even when the indoor unit is turned o after cooling mode is turned to heating mode .
X Do not install the electronic heater in the flow channel of the indoor unit fan.
Air Flow
Suction side Discharge side
Electronic heater should not
be installed.
Duct Indoor unit
Q 05 series installation option
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
05
Use of Auto Change
Over for HR only in
Auto mode
(When setting SEG3)
Standard heating temp.
Oset
(When setting SEG3)
Standard cooling temp.
Oset
(When setting SEG3)
Standard for mode
change
Heating → Cooling
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1
(When setting SEG3)
Standard for mode
change
Cooling → Heating
(When setting SEG3)
Time required for mode
change
Compensation option
for Long pipe or height
dierence between
indoor units
--
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2----
Control variables when
using hot water / external
heater
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3-----
Setting an indoor unit address and installation option(Continued)