Disassembly and Reassembly
Samsung Electronics 51
No Parts
Procedure Remark
2 DRAIN PAN 1) Remove the 4 screws fixed in DRAIN PAN. (Use
+Screw Driver)
2) Pull the DRAIN PAN from the indoor unit and
remove.
By Hair-Pin, be careful not to damage and
weldment is flowed in.
When you remove the DRAIN PAN, be careful
not to fall off the remaining water.
3 Electrical equipment 1) Remove the 2 screws fixed in Electrical equip-
ment and then remove the cover. (Use +Screw
Driver)
2) Push up as shown in the figure with hand and
then disconnect the 8 connectors from the
indoor unit PCB.
3) Lift up the control part and remove.
To Next Page
Loading...
