20
6. When the remote control does not operate
6. When the remote control does not operate
1) Troubleshooting procedure
Troubleshooting (cont’d)
ΙΙΙ
Remove the power cord and plug it in again approx. five Seconds
Does the STD lamp blink?
Check as the procedure “No Power”
Refer to page 16
Normal
Replace the battery
LCD is abnormal.
Replace button
Micom is abnormal.
Receiver module is abnormal.
Q601(C4375Y) or Q602(C1623Y)
is
abnormal.
IR LED(CL-1L5EU) is
abnormal.
The melody sounds from the indoor unit when you
push the On/Off button on the remote control.
Is voltage of battery less than 2.5V (Remote Control Unit)?
Is LCD display status of the remote control normal?
Is voltage of #30 of remote control of Micom (IC04) changed?
Is voltage at collector of Q601 or Q602 changed?
Is voltage of #26 of Micom (IC04) changed (Indoor unit)?
Micom (IC04) is abnormal.
NO
YES
YES
NO
NO
NO
NO
YES
NO
YES
YES
YES
YES
NO
NO
YES
Does the transmission display lamp blink when you
push the On/Off button on the remote control?
AQ18A5(6)RC SM_E_15778 2/12/04 9:10 PM Page 20
To Next Page
Loading...
