What to do if the timer LED is on but the Samsung AQ18A6RC won't turn on?
If the timer LED on your Samsung Air Conditioner's indoor unit is lit but the unit isn't running, it means the timer is active and the unit is in standby. To make the unit operate normally, you need to cancel the timer setting.
Why does the compressor stop intermittently in COOL or DRY mode and the fan speed decreases on my Samsung AQ18A6RC Air Conditioner?
If your Samsung Air Conditioner's compressor stops and the indoor fan slows down in COOL or DRY mode, it's a safety measure. This happens to prevent the inside or outside air from freezing, depending on the air temperature inside and outside.
Why do the compressor and indoor fan stop intermittently in HEAT mode on my Samsung Air Conditioner?
The compressor and indoor fan in your Samsung Air Conditioner might stop occasionally in HEAT mode to prevent overheating. This occurs when the room temperature gets higher than the set temperature, protecting the compressor.
Why do the indoor and outdoor fans stop intermittently in HEAT mode on my Samsung Air Conditioner?
In HEAT mode, your Samsung Air Conditioner may temporarily stop the indoor and outdoor fans to remove ice from the exterior. This reverse cycle operation is normal and should occur for no more than 20% of the total heating time.
Why does the compressor stop intermittently in DRY mode on my Samsung Air Conditioner?
When operating in DRY mode, the compressor of your Samsung Air Conditioner is automatically controlled based on the room's temperature and humidity. This intermittent stopping is normal.
How to set fan speed on Samsung AQ18A6RC Air Conditioner in AUTO or DRY mode?
In DRY mode, the indoor fan speed is fixed at LL. In AUTO mode, the fan speed is automatically selected from 5 steps.
Why can't I set the fan speed on my Samsung AQ18A6RC in AUTO or DRY mode?
The indoor fan speed on your Samsung Air Conditioner cannot be adjusted when it's in AUTO or DRY mode. In DRY mode, the fan speed is automatically set to LL (Low Low). In AUTO mode, the fan speed is automatically adjusted through 5 steps.
Why is the STD operation LED blinking when I plug in my Samsung Air Conditioner for the first time?
The STD operation indication LED blinking on your Samsung Air Conditioner when you first plug in the indoor unit simply means that the power is on. To stop the blinking, press the ON/OFF button on the remote control.
Why does my Samsung Air Conditioner compressor not operate in COOL mode?
The compressor might be experiencing a 3-minute delay upon reoperation or initial power-on. During this delay, the indoor fan automatically adjusts based on the temperature of the blown air.
Why does my Samsung Air Conditioner compressor stop in COOL or DRY mode?
The compressor might be stopping intermittently, or the fan speed decreasing, to prevent the air from freezing inside or outside depending on the air temperature.
General| Brand | Samsung |
|---|---|
| Model | AQ18A6RC |
| Category | Air Conditioner |
| Language | English |
To Next Page