Samsung AQ18VBA - Page 56

3-4 Setting Option Setup Method
ex) Option No. :
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temperature button simultaneously and insert
the battery again.
3
rd
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
The default value is .
Otherwise, push the
button to .
Every time you push the button, the display panel reads or
repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
 
 . . .        repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
 
 . . .        repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
 
 . . .        repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
 
 . . .        repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
 
 . . .        repeatedly.
1
1
 Setting is not required if you must
a value which has a default.
2
3
4
5
6
3 2
1
4
5
6
10
Samsung Electronics3-4