18
Remote Control Operation
English
At a GlanceAt a Glance
Selecting an operation mode
To change the current mode between Auto, Cool, Dry, Fan, and Heat,
press the (Mode) button.
You can use AI Auto mode after Wi-Fi is connected.
NOTE
You can use the Cool, Dry, and Heat modes in the following operation
range.
Mode Cool Dry Heat
Indoor
temperature
16 °C to 32 °C 18 °C to 32 °C 27 °C or less
Outdoor
temperature
-10 °C to 46 °C -10 °C to 46 °C
Indoor
humidity
Relative
humidity of
_ _
environment for an extended period of time, condensation may
occur.
For more information about outdoor temperature in the multi
system, refer to the manual for the multi system.
You can switch between Celsius and Fahrenheit indications on the
remote control.
Press and hold for 3 or more seconds.
NOTE
The temperature indications on the indoor unit are not switched.
This function is canceled when the remote control batteries are
replaced. In this case, run this function again.
You can use the air conditioner easily by selecting a mode and then by controlling the temperature, fan
speed, and air direction.
Remote Control Operation
To Next Page
Loading...
