51
Remote Manual
Timer operation
Press the TIMER ON button can set the auto-on
time of the unit. Press the TIMER OFF button
can set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-
on setting time and the signal “H” will be
shown on the LCD display area. Now it is
ready to reset the Auto-on time to START
the operation.
2. Push the TIMER ON button again to set
desired Auto-on time. Each time you press
the button, the time increases by half an
hour between 0 and 10 hours and by one
hour between 10 and 24 hours.
3. After setting the TIMER ON ,there will be
a one second delay before the remote
controller transmits the signal to the air
conditioner. Then, after approximately
another 2 seconds, the signal “h” will
disappear and the set temperature will
re-appear on the LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-
off setting time and the signal “H” will be
shown on the LCD display area. Now it is
ready to reset the Auto-off time to stop the
operation.
2. Push the TIMER OFF button again to set
desired Auto-off time. Each time you press
the button, the time increases by half an
hour between 0 and 10 hours and by one
hour between 10 and 24 hours.
3. After setting the TIMER OFF ,there will
be a one second delay before the remote
controller transmits the signal to the air
conditioner. Then, after approximately
another 2 seconds, the signal “H” will
disappear and the set temperature will
re-appear on the LCD display window.
2
1
To Next Page
Loading...
