4-38
Troubleshooting
- Try-run Check Error
Contents
Q1
Check point Remarks
Analysis
These Error codes only apply with Try-run mode, in case of system have some defect as result of
try-run operation.
Contents
Q6
Check point Remarks
Analysis
Heating overload safety mode make this situation.
After System restart automatically until 3 times, System display this error code and stop.
System can operate by remote controller input signal or K3(reset) key input.
Step 1
Step 2
Contents
Q7
Check point Remarks
Analysis
The product is out of the range of heating operation.
Please, Remember Heating operation range.
To Next Page
Loading...