Samsung AR7000 - Extending the Assembly Cable; Connecting Indoor and Outdoor Unit Cables

2 . Open the cover panel.
3 . Remove the screw securing the connector cover.
4 . Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals.
(Refer to the picture below)
t &BDIXJSFJTMBCFMFEXJUIUIFDPSSFTQPOEJOHUFSNJOBMOVNCFS
5 . Pass the other end of the cable through the 2.56inch(65mm) hole in the wall.
6 . Close the connector cover by tightening the screw carefully.
7 . Close the cover panel.
8 . Remove the terminal board cover on the side of the outdoor unit.
9. Connect the cables to the terminals as seen in the picture.
t &BDIXJSFJTMBCFMFEXJUIUIFDPSSFTQPOEJOHUFSNJOBMOVNCFS
*OEPPSVOJU
0VUEPPSVOJU
t "MTPDJSDVMBSUFSNJOBMNVTUCFNBUDIFEXJUITDSFXTJ[FJOUFSNJOBMCMPDL
t "GUFSDPOOFDUJOHUIFDBCMFTNBLFTVSFUFSNJOBMOVNCFSTPOUIFJOEPPSPVUEPPSVOJUNBUDIFT
t 1MFBTFFOTVSFUIBU1PXFS$PNNVOJDBUJPODBCMFTBSFTFQBSBUFEUIFZNVTUOPUCFJOUIFTBNFDBCMF
U
10. Connect the grounding conductor to the grounding terminals.
11. Close the terminal board cover by tightening the screw carefully.
t *O3VTTJBBOE&VSPQFDPOTVMUXJUIUIFTVQQMZBVUIPSJUZUPEFUFSNJOFUIFTVQQMZTZTUFNJNQFEBODFCFGPSF
JOTUBMMBUJPO
t $POOFDUUIFXJSFTöSNMZTPUIBUXJSFTDBOOPUCFQVMMFEPVUFBTJMZ
*GUIFZBSFMPPTFJUDPVMEDBVTFCVSOPVUPGUIFXJSFT
t $POOFDUUIFXJSFTBDDPSEJOHUPDPMPSDPEFTSFGFSSJOHUPUIFXJSJOHEJBHSBN
t 5IFQPXFSDBCMFBOEUIFJOUFSDPOOFDUJPODBCMFTIPVMECFTFMFDUFEBDDPSEJOHUPUIFTQFDJöDBUJPOJOQBHF
L1
L2
F1
F2
L1
L2
F 1
F 2
L1
L2
F 1
F 2
*OEPPSVOJU
0VUEPPSVOJU
1. Extend the assembly cable if necessary.
t %POPUDPOOFDUUXPPSNPSFEJòFSFOUDBCMFTUPFYUFOEUIFMFOHUI
*UNBZDBVTFöSF
English-43
INSTALLATION07
AR7000 CV HP_IB&IM_DB68-05637A-00_EN.indd 43 2015/10/16 10:33:09