E-37
ENGLISH
INSTALLING THE OUTDOOR UNIT
Connecting the Cables to the Outdoor Unit
One electric cable must be connected to the outdoor unit:
◆ The assembly cable connecting the indoor unit to the outdoor unit
1 Remove the terminal board cover on the side of the outdoor unit.
2 Connect the assembly cable to terminals as shown in the figure.
➢ Each wire is labelled with the corresponding terminal number.
➢ Each wire from the terminal number of the indoor unit.
Shall be comected with the same terminal number of its
outdoor unit.
3 Connect the earth wires to the earth terminals.
➢ Refer to the page 39 for further details on how to check
that earthing is correct.
4 Replace the terminal board cover, carefully tightening the screw.
✴✴07/09✴✴
AS12A5(A6)MC
✴✴18/24✴✴
AS12AA(AB)MC