Removing Excess Humidity
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1
If necessary, press the button.
Result:
The operation indicator on the indoor unit lights up.
The air conditioner starts up in Cool mode with
Turbo fan speed.
The indoor unit beeps.
IMPORTANT
The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2
If the is not displayed at the top of the remote control,press the
button on the remote control one or more times until it appears.
Result:
The indoor unit beeps each time you press the button.
The air conditioner runs in the Dry mode.
Note
You can change modes at any time.
3
To adjust the temperature, press the
button one or more times until
the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result:
Each time you press the button:
- The temperature is adjusted by 1°C
- The indoor unit beeps
The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
The fan is running in auto mode.
4 To control the direction of the air flow, refer to page 13.
To Next Page
Loading...
Need help?
General
