Removing Excess Humidity
=
Remote Control Control Panel
ff the atmosphere in your room is very humid or damp. you can remove
excess humidity without lowering the room temperature too much.
1 If necessary, press the _ (On/Off) button.
Result: • The air conditioner starts up in the Cool mode.
• The unit beeps.
_ql"
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
• Plugged in
• Stopped
It will begin to cool after three minutes.
If the temperature is not displayed on the control panel:
• Press the _ button on the remote control
or"
• Press the _ button on the unit one or more times until ,'_ is displayed.
Result: • The unit beeps each time you press the _/_ button.
• The air conditioner starts up in the Cool mode.
You can change modes at any time.
To adjust the temperature, press the l--Z-] or _ buttons one or
more times until the required temperature is displayed.
The temperature can be set between 64°F and 86°F.
Result: • Each time you press the I--S--'lor _ buttons:
- The temperature is adjusted by I°F
- The unit beeps
• The air conditioner starts removing the excess humidity;
the quality of air is adjusted automatically.
4 To control the direction of the air flow, refer to page 11.
®
To Next Page
Loading...
