Cooling Your Room
RemoteControl ControlPanel
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the Fan speed.
Press the (,D (On/Off) button.
Result: 4, The air conditioner starts up in the Cool mode.
4, The unit beeps twice.
2
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
4, Plugged in
4, Stopped
It will begin to cool after three minutes
If the temperature is not displayed on the control panel:
4, Press the _ button on the remote control
or
4, Press the _ button on the unit one or more times until ::' is displayed.
Result: 4, The unit beeps each time you press the _/_ button.
4, The air conditioner starts up in the Cool mode.
You can change modes at any time.
4
To adjust the temperature, press the _or _ buttons on the remote
control or unit one or more times until the desired temperature is displayed.
The temperature can be set between 64°F and 86°F.
Result: 4, Each time you press the r--Z-]or I-77 buttons:
- The temperature is adjusted by I°F and displayed on
the control panel
- The unit beeps
4, If the room temperature is higher than the selected temperature,
the air conditioner starts cooling.
4, If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan still operates.
To set the fan speed:
4, Press the Q, Q or@ button on the remote control as desired.
or
4, Press the _ button on the unit one or more times until the
desired Fan speed(F1, F2 or F3) is displayed.
5 To control the direction of the air flow, refer to page tt.
0
To Next Page
Loading...
