17
Removing the Stand
―
Before removing the stand from the monitor, place the monitor on a flat and stable surface with the screen facing down.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
1
2
3
2-3 cm
4
Remove the stand base from the stand neck. Lift the stand neck. Disassemble and remove the COVER-REAR SUB. Disconnect the cables.
5
6
Push a thin stick into the stand eject hole and
rotate the stand neck counterclockwise, as shown
in the figure.
Lift and remove the stand. - Caution
Do not press down on the monitor. There is a risk of
damaging the monitor.
To Next Page
Loading...
