English - 9English - 8
02 InstallatIon & MaIntenance
Installation
Installation site
•
Select a at, level surface approx.
85cm above the oor. The surface
must support the weight of the
oven.
•
Secure room for ventilation, at
least 10cm from the rear wall and
both sides, and 20cm from above.
•
Do not install the oven in hot or
damp surroundings, such as next
to other microwave ovens or
radiators.
•
Conform to the power supply specications of this oven. Use only
approved extension cables if you need to use.
•
Wipe the interior and the door seal with a damp cloth before using your
oven for the rst time.
Turntable
Remove all packing materials inside
the oven. Install the roller ring and
turntable. Check that the turntable
rotates freely.
Maintenance
Cleaning
Clean the oven regularly to prevent impurities from building up on or inside
the oven. Also pay special attention to the door, door sealing, and turntable
and roller ring (applicable models only).
If the door won’t open or close smoothly, rst check if the door seals have
built up impurities. Use a soft cloth in soapy water to clean both the inner
and outer sides of the oven. Rinse and dry well.
To remove stubborn impurities with bad smells from inside the oven
1. With an empty oven, put a cup of diluted lemon juice on the centre of the
turntable.
2. Heat the oven for 10minutes at max power.
2. When the cycle is complete, wait until the oven cools down. Then, open
the door and clean the cooking chamber.
To clean inside swing-heater models
To clean the upper area of the
cooking chamber, lower the top
heating element by 45° as shown.
This will help clean the upper area.
When done, reposition the top
heating element.
• Keepthedooranddoorsealingcleanandensurethedooropens
and closes smoothly. Otherwise, the oven’s lifecycle may be
shortened.
• Takecautionnottospillwaterintotheovenvents.
• Donotuseanyabrasiveorchemicalsubstancesforcleaning.
• Aftereachuseoftheoven,useamilddetergenttocleanthe
cooking chamber after waiting for the oven to cool down.
Replacement (repair)
This oven has no user-removable parts inside. Do not try to replace
or repair the oven yourself.
• Ifyouencounteraproblemwithhinges,sealing,and/orthedoor,
contact a qualied technician or a local Samsung service centre for
technical assistance.
• Ifyouwanttoreplacethelightbulb,contactalocalSamsung
service centre. Do not replace it yourself.
• Ifyouencounteraproblemwiththeouterhousingoftheoven,
rst unplug the power cord from the power source, and then
contact a local Samsung service centre.
Care against an extended period of disuse
If you don’t use the oven for an extended period of time, unplug the power
cord and move the oven to a dry, dust-free location. Dust and moisture that
builds up inside the oven may affect the performance of the oven.