Disassembly & Reassembly
12-2 Samsung Electronics
Part Name Description Description Photo
Chassis
Holder
① Separate the Ass'y Holder chassis from the Front Cabinet.
② Pull the Chassis Holder lifting the fixing clip up.
: Pulling the Chassis Holder by force may damage the clip or
the connector. Pull the Chassis Holder just until the clip comes
off the hole.
① Separate the Speakers, the Side AV Wire, and the D-Coil, DY
and the power cable from the Front
Cabinet and the Main Ass'y.
② Slide the fixing clip aside and lift the wire upwards to
separate the DY and the power cable.
: Since there is a clip to connect the Connector Header in the
Wire Connector, pulling it by force may damage the clip or the
connector. Press the clip down completely and pull the
connector.
① Separate the CRT Ass'y from the CRT.
② Separate the TBC wire, GND, VM and Tilt cables from the
CRT Ass'y sequentially.
① Separate the cables connecting the FBT and the CRT.
: Since there may be a remaining high-voltage current within
the CRT, take care not to touch the CRT hole with metal or a
part of yourself when separating the cables.
the Holder Chassis.
To Next Page
Loading...
