Disassembly & Reassembly
Samsung Electronics 12-3
Part Name Description Description Photo
CRT Ass'y
① Separate the cables from the Main Ass'y and CRT Ass'y.
① Separate the wires from the FBT of the Main Ass'y and the
CRT Ass'y.
② To separate the thick white wires, pull the wires while
pressing the push-type clip at the connector.
③ To separate the thin red wire, insert a pin in the small hold
next to the hole and pull the wire.
: Take care when separating the wires because pulling the
wires by force may damage the socket. In addition, separate the
wires on a flat and clean surface so as to prevent scratching of
the material and the PCB.
pressing on the fixing clip.
12-1-3 Disassembling the CRT Ass'y
Part Name Description Description Photo
Main Ass'y
① Remove the 2 screws fixing the Main PCB.
: PWH, +, B, M3, L10, ZPC(YEL), SWRCH18A
② Separate the holder.
12-1-4 Disassembling the Main Ass'y and Holder
To Next Page
Loading...
