Alignment & Troubleshooting
Service Manual
4-10
Samsung Electronics
Inside the machine
1. Open and close the front cover. The jammed
paper is automatically ejected from the machine.
If the paper does not eject, go to the next step.
2. To remove the jammed paper, open the rear
cover.
3. Carefully remove the jammed paper by pulling
in the direction as shown below. Most of the
jammed paper can be removed in this step.
If the paper does not eject when you pull, or if
you do not see the paper in this area, check the
paper exit area.
4. Close the rear cover. Make sure that it is
securely closed. Printing automatically resumes.
In the paper exit area
1. Gently pull the paper out the output tray.
If you do not see the jammed paper or if there is
any resistance when you pull, stop and go to the
next step.
2. To remove the jammed paper, open the rear
cover.
To Next Page
Loading...
