"File in Use" message appears
during installation.
Exit all software applications. Remove all
software from the StartUp Group, then
restart Windows. Reinstall the printer driver.
"Error Writing to LPTx"
message appears.
·Ensure that all cables are connected
correctly and the printer is on.
·If bi-directional communication is not
turned on in the driver, it will also cause
this message.
"General Protection Fault",
"Exception OE", "Spool32", or "Illegal
Operation" messages
appear.
Close all other applications, reboot
Windows and try printing again.
"Fail To Print", "A printer
timeout error occurred."
messages appear.
These messages may appear during printing.
Just keep waiting until the printer finishes
printing. If the message appears in standby
mode or after printing has been completed,
check the connection and/or whether an
error has occurred.
To Next Page
Loading...
