Samsung CLP-350N - Screws Used in the Printer

Samsung Electronics
Service Manual
Disassembly and Reassembly
3-6
3.3.2 Screws used in the printer
The screws listed in the table below are used in this printer. Please ensure that, when
you disassemble the printer, you keep a note of which screw is used for which part and
that, when reassembling the printer, the correct screws are used in the appropriate
places.
S1 6009-001396 SCREW-SPECIAL;PH,+,-,M3,L10.3, PTB Draw Connector 2
ZPC(BLK),SWRCH18A,B TITE,-
S2 6003-000269 SCREW-TAPTITE;BH,+,-, BRACKET-CONT LOWER + Assy Network Card 2
S,M3,L6,ZPC(YEL),SWRCH18A,-
BRACKET-CONT LOWER + 4
BRACKET-CONT UPPER
BRACKET-CONT LOWER + MAIN PBA 4
BRACKET-CONT UPPER + BRACKET-POWER 2
SUB MAIN FRAME + BRACKET-CONT LOWER 2
SUB MAIN FRAME + UNIT SMPS 2
BRACKET-CONT UPPER + IPR-SHIELD SIMM 1
BRKT-SHIELD SMPS + SMPS type5 + Fuser BD 8
FRAME-FRONT + FRAME-REAR + FRAME-BOTTOM 4
SUB MAIN FRAME + PBA DRIVE 3
MEA-FRAME BASE + CHANNEL FRAME BASE 3
S3 6003-000275 SCREW-TAPTITE;BH,+,B,M3,L10,BLK, MAIN FRAME + COVER-REAR 4
SWCH1018AK
DRAW CONNECTOR 2
S4 6003-001086 SCREW-TAPTITE;BH,+,B,M3,L12, SUB MAIN FRAME + BRACKET-MPF 1
ZPC(BLK),SWRCH18A
SUB MAIN FRAME + SUB PICK-UP 1
UNIT MPF + BRACKET-MPF 1
MEA-ASSY-MPF + GUIDE-PAPER-MP 2
MEA-UNIT FRAME BASE + MEA-ASSY-MPF 3
S5 6003-000261 SCREW-TAPTITE;BH,+,B,M3,L6, HOUSING-OPC 8
ZPC(YEL),SWRCH18A
S6 6003-000282 SCREW-TAPTITE;BH,+,B,M3,L8, F/M_Upper-Fuser + C/M_Carbon-Brush 2
ZPC(BLK),SWCH10
FRAME ASSY 28
FRAME-PTB ASS'Y 28
COVER-M-OP FRAME LED + Cover DECO 4
COVER-M-OP FRAME LED + LED PBA 7
NO SEC CODE DESCRIPTION & SPECIFICATION LOCATION QT'Y