Samsung CM1099 Series - Replacement of Drive Motor

14
4. Disassembly and Reassembly
4-4 Replacement of Drive Motor
Parts Explaination Photo Explaination
Drive Motor
1. Take out the glass tray,
guide roller from oven cavity,
disconnect power.
2. Remove turn table motor cover
from case bottom.
CAUTION : Remove sharp edge
after cover removal.
3. Disconnect leads from motor.
4. Remove the screws securing
motor to bottom of over cavity.
Drive Motor
6. Lift out the motor.
5. When replacing the motor, be
sure to remount it in the correct
position.
NOTE : The shaft of motor should
¿WWLSFRXSOHU
COVER FIXING SCREW :
MATCHINE SCREW(6006-001170)
6. When reassemble a drive
motor cover. give a turn in a
DQG¿[ZLWKDVFUHZ
NOTE : Bring the spare screw
from service center.