GB
10
2. Remove 6 screws as shown in the figure.
3. Place the Bracket-plate to join the two units.
4. Attach and tighten 6 screws as shown in the figure here.
5. Ensure the top oven is at a safe and workable height.
Replacement of Lamp
Important
1. Remove a screw securing the lamp cover.
✉ You don’t need to remove outer panel to replace lamp.
2. Remove the lamp by rotating it clockwise.
3. Replace with a new lamp by rotating it counter-clockwise.
Screw
Bracket-Plate
Outer
Panel
Lamp
Cover
Lamp Holder
Lamp
(230V 25W)
CM1919_GB.fm Page 10 Thursday, April 11, 2002 9:22 AM
To Next Page
Loading...
