Samsung CM1929/N - Double Quantity Pad Programming; Controlling Beep Tone

14
ENGLISH
DOUBLE QUANTITY PAD PROGRAMMING
1. Hold down ( ) and then press ( ) pad. Hold
together for 2 seconds.
2. Select desired program code by using NUMBER
pads.
3. Press NUMBER pads to set the magnification
factor within the range from 1.00 to 9.99.
Default factor is 1.65 preset from the manufacturer
for increasing the cooking time.
Make sure that you set a correct factor between 1.00 and 9.99 for each
memory code number.
4. Press ( ) button.
Press pad to exit the programming mode.
Though you can successfully set a double quantity factor whose setting
might result in excess of the maximum time allowed for each power
level, the oven does not operate exceeding the maximum time.
Double Quantity Factor Editing
Feature Key Entry Display Remark
Double
Quantity
Factor
Edit
Hold down
CANCEL ( )
and then ( )
pad.
Hold down for 2 sec.
Code No.
After 1 sec, default value
shows in the display window.
(Input desired
factor value.)
1.00 ~ 9.99 available (Change
the factor if required.)
START ( )
If you don’t want to change
more, press CANCEL to exit
the editing mode.
New Code No.
Skip this step if not
necessary.
(Input desired
factor value.)
Skip this step if not
necessary.
START ( )
Skip this step if not
necessary.
CANCEL ( )
(Mode cancel) This exits the editing mode.
CONTROLLING BEEP TONE
You can select the beep tone you require. There are 4 sound levels
available.
Hold down CANCEL ( ) and then press NUMBER
0 pad. Hold together for 2 seconds.
Result : Beep tone is changed to one level
higher than current one.
Beep tone 0 does not make beep sound.
Settings are circulating whenever you press the hidden keys in the
following order.
Snd 0 g Snd 1 g Snd 2 g Snd 3 g Snd 0 (No sound)
Default tone is Snd 2.