EN
17
Installation Instructions for Stacking
Important
1. Disconnect the power cord from the wall socket before attempting installation.
2.
For stacking installation, you must use the “bracket plate” which is enclosed with
this unit.
3.
The maximum stacking height is two units.
Stacking the two units is limited to the following models.
CAUTION: Be sure the oven cavity is empty.
Installation
1. Stack two units together.
2.
Remove 6 screws as shown in the figure.
3.
Place the Bracket-plate to join the two units.
4.
Attach and tighten 6 screws as shown in the figure here.
5.
Ensure the top oven is at a safe and workable height.
Replacement of Lamp
Important
1. Remove a screw securing the lamp cover.
You don’t need to remove outer panel to replace lamp.
2.
Remove the lamp by rotating it clockwise.
3.
Replace with a new lamp by rotating it counter-clockwise.
Screw
Bracket-Plate
Lamp Cover
Outer Panel
Lamp Holder
Lamp
(230V 25W)
jtX`Y`hl|TWYZ[`iluUGGwGX^GGtSGqGY_SGYWW_GGYaW_Gwt
To Next Page
Loading...
