English - 23
Selecting the Sound Mode (depending on the model)
The DUAL I-II button displays/controls the processing and output of the audio signal. When power is switched on, the mode is
automatically preset to either “Dual-I ” or “Stereo”, depending on the current transmission.
Type of broadcast On-screen indication
NICAM
Stereo
Regular broadcast
(Standard audio)
Mono (Normal use)
Regular + NICAM
Mono
Mono
NICAM
↔
Mono
(Normal)
NICAM Stereo
Stereo
NICAM
↔
Mono
(Normal)
NICAM Dual-I/II
Dual-I
NICAM
→
Dual-II
NICAM
→
Mono
(Normal)
A2
Stereo
Regular broadcast
(Standard audio)
Mono (Normal)
Bilingual or Dual-I/II Dual-I
↔
Dual-II
Stereo Stereo
↔
Mono
(Forced mono)
➢
◆ If the receiving conditions deteriorate, listening will be easier if the mode is set to the
Mono
.
◆ If the stereo signal is weak and an automatic switching occurs, then switch to the
Mono
.
◆ When receiving a mono sound in the AV mode, connect to the “AUDIO-L” input connector on the panel (front or side).
If the mono sound comes out only from left speaker, press the DUAL I-II button.
To Next Page
Loading...
