Samsung DB10D

111
Auto Power On
This feature automatically turns on the product as soon as it is plugged in. Pressing the power button is not needed.
•
Off / On
Max. Power Saving
Turns off the product to reduce power consumption after the PC has been left idle for a specified period of time.
•
Off / On
Standby Control
You can set the screen standby mode to be applied when an input signal is received.
•
Auto
Power-saving mode will activate if no input signals are detected even though a source device is connected to the display.
The message No Signal will appear if no source device is connected.
•
Off
The message No Signal will appear if no input signals are detected.
―
If No Signal is displayed although a source device is connected, check the cable connection.
―
If No Signal Message is set to Off, the No Signal message does not appear.
If this is the case, set No Signal Message to On.
•
On
Power-saving mode will activate if no input signals are detected.
Power Control
MENU m → System → Power Control → ENTER E
Power Control
Auto Power On
Max. Power Saving
Standby Control
Power Button
Network Standby
O
On
On
Power on only
O
-
The displayed image may differ depending on the model.