English - 31
03 OPERATION
Rack dry (applicable models only)
Installing the drying rack
1. Open the dryer door.
2. Position the drying rack in the tumbler, placing the front lip of the
drying rack (A) on the top of the lint filter.
3. Place the rear legs in the two recessed areas of the dryer’s back wall,
and then push down the middle of the drying rack to fix in place.
4. Place the items to be dried on the rack, leaving space between them
so air can circulate.
5. Close the dryer door.
6. Press Rack Dry or other Cycle Setting according to rack drying
suggestions below, then select the drying time.
A
Drying rack drying suggestions
SUGGESTED ITEMS SUGGESTED TEMP. SETTINGS
Washable sweaters
(block to shape and lay flat on rack)
Extra Low (TIME DRY cycle)
Stuffed toys
(cotton or polyester fiberfilled)
Extra Low (TIME DRY cycle)
Stuffed toys
(foam or rubber-filled)
AIR FLUFF
Foam rubber pillows AIR FLUFF
Sneakers AIR FLUFF
Drying foam rubber, plastic, or rubber on a heat setting may cause damage to the items and lead to a fire
hazard.
The drying rack is not included in the DV42H5200* and DV42H5000* models.
You can purchase the drying rack (part code: DC93-00374G) at a local Samsung service center.
DV5000H_DC68-03381A-19_EN.indd 31 2020-03-09 1:45:52
To Next Page
Loading...
Need help?
General