English - 24
11. Fit the lower area of the holder lever in the frame-front hole in the
arrow direction, and push in the holder lever to the end while holding
down the hook (A).
A
12. Reattach the screws in the remaining holes.
13. When the holder lever is attached properly, it is supposed to be flexible
in all four directions.
Final installation checklist
• The dryer is plugged into an electrical outlet and is properly grounded.
• The exhaust ductwork is hooked up and the joints are taped.
• A plastic flexible duct is NOT used.
• Use rigid or stiff-walled flexible metal vent material.
• The dryer is level and is sitting firmly on the floor.
• Gas models – the gas is turned on with no gas leaks.
• Start your dryer to confirm that it runs, heats, and shuts off.
DV5000H_DC68-03381A-19_EN.indd 24 2020-03-09 1:45:51
To Next Page
Loading...
Need help?
General