Samsung DV457EVGSGR/AA

Other manuals for Samsung DV457EVGSGR/AA

Technical Information42 pages

Questions and Answers

T
Thomas RiosAug 15, 2025
Why my Samsung DV457EVGSGR/AA Dryer will not start?
- J
  Jennifer BennettAug 15, 2025
  If your Samsung Dryer isn't starting, ensure all wires are correctly connected to their terminals and that the dryer is properly plugged in. Also, check for a blown fuse or tripped circuit breaker. Verify the door switch is functional and the door is fully closed; an error code 3 might indicate a door issue. Confirm the Start/Pause rotary selector dial and the Control Board are working. Inspect the belt for damage or if it's off, and ensure the Belt Cut-off Switch is operating correctly. Finally, check if the drive motor is functional and verify the motor winding resistance: it should be 2.88 ohms between pin #3 and 4, and 3.5 ohms between pin #4 and 5.
B
Brandon BellAug 18, 2025
Why does my Samsung DV457EVGSGR/AA (Gas Model) keep blowing fuses or tripping the circuit breaker?
- J
  Jennifer HowardAug 18, 2025
  If your Samsung gas dryer blows fuses or trips the circuit breaker, it could be due to several reasons. During ignition, the dryer draws a specific amperage; if it's drawing more than usual with the burner on, the issue might be with your house wiring, fuse box, or circuit breaker. Other potential causes include a loose igniter harness shorted to the base, incorrect wiring or a wire shorted to ground, or a drive motor winding shorting to ground. Check these components to resolve the issue.
J
Jeremy GarciaAug 21, 2025
What to do if Samsung DV457EVGSGR/AA motor runs but the tumbler won't turn?
- J
  Jodi BauerAug 21, 2025
  If your Samsung Dryer motor runs but the tumbler won't turn, the belt might be off, broken, or damaged. Alternatively, the idler tension spring could be too weak or stretched, or the idler pulley might be jammed or stuck. Inspect these components to resolve the issue.
S
steven07Aug 25, 2025
Why does my Samsung DV457EVGSGR/AA run a few minutes and then stops?
- R
  Ronald SharpAug 25, 2025
  If your Samsung Dryer runs for a few minutes and then stops, it could be due to lint buildup around the drive motor. Other potential causes include low voltage, a blocked blower impeller in the blower housing, or the drive motor's start switch contacts being stuck closed. Check these areas to troubleshoot the issue.
D
Daniel SmithAug 27, 2025
What to do if my Samsung DV457EVGSGR/AA Dryer will not heat but motor runs?
- R
  rangellisaAug 27, 2025
  If your Samsung Dryer won't heat but the motor is running, check for an open heating element, a hi-limit that trips easily or is open, or a regulating thermostat that trips easily or is open. Also, inspect the membrane switch for being open and check the thermistor.
J
Jacob BurgessAug 30, 2025
How to fix improper drying, wrinkled clothes and long dry time with my Samsung DV457EVGSGR/AA Dryer?
- B
  Benjamin HoustonAug 30, 2025
  If your Samsung dryer is producing wrinkled clothes, or the texture is rough, or the drying time is too long, consider the following: * Make sure the lint filter is clean. * Check for any restrictions in the exhaust system. * Ensure the outside exhaust hood damper door isn't stuck closed. * Verify the exhaust isn't too long, doesn't have too many elbows, and doesn't use flexible ductwork. * Ensure the dryer has adequate intake air. * Check the tumbler speed and belt for slipping. Also, check the blower impeller for obstructions and avoid overloading the dryer. Finally, review clothing labels for fabric content and the selected cycle, and ensure clothes aren't too wet from the washer.
J
joshua23Sep 2, 2025
How to troubleshoot a noisy and vibrating Samsung Dryer?
- B
  Brittany CraigSep 2, 2025
  If your Samsung Dryer is making unusual noises or vibrating, here's what to check: * Thumping: Inspect for loose tumbler baffles, worn or misaligned rear tumbler rollers, an out-of-round tumbler, or a high weld seam on the tumbler. * Ticking: Look for a loose wire harness or an object caught in the blower wheel area. * Scraping: Check the front or rear bulkhead felt seal for being out of position or worn tumbler front bearings. * Roaring: See if the blower wheel is rubbing on the blower housing or if there are bad motor bearings. * Popping or squealing: Inspect for a sticky or frayed belt.
Q
qcohenSep 5, 2025
Why the igniter does not glow in my Samsung DV457EVGSGR/AA Dryer?
- G
  grayemilySep 5, 2025
  If the igniter in your Samsung Dryer does not glow, check for an open flame sensor or an open igniter. Also, look for a shorted booster coil, open wiring, a bad motor switch (neutral supply), or a lack of power from the control (L1 supply).
T
Tim MillerSep 8, 2025
What causes the igniter to glow, but no gas ignition in Samsung DV457EVGSGR/AA?
- D
  deborah21Sep 8, 2025
  If the igniter glows but there is no gas ignition in your Samsung Dryer, check for an open secondary coil or an open holding coil. Also, inspect the wire harness for any opens and ensure the flame sensor is not stuck closed.
M
Mr. Jesse Young MDSep 12, 2025
Why gas is ignited but the flame goes out in my Samsung Dryer?
- J
  Jamie KochSep 12, 2025
  If the gas ignites but the flame goes out in your Samsung Dryer, it could be due to radiant sensor contacts opening prematurely, a weak gas valve coil that may open when stressed by higher temperatures, or a weak hi-limit. Other potential causes include poor venting or bad drum seals.

Summary

Features

Extra Large Capacity

Describes the dryer's drum size and its benefits for large loads.

8 LCD Touch Screen Display

Smart Care

Safety instructions

WHAT YOU NEED TO KNOW ABOUT SAFETY INSTRUCTIONS

Provides essential information on safe dryer operation.

IMPORTANT SAFETY SYMBOLS AND PRECAUTIONS

Explains hazard symbols and their meanings for safe usage.

Installing your dryer

DUCTING REQUIREMENTS

Specifies guidelines for the exhaust duct system for optimal performance.

IMPORTANT TO INSTALLER

LOCATION CONSIDERATIONS

EXHAUSTING

Detailed instructions on how and where to properly exhaust the dryer.

GAS REQUIREMENTS

Specifies gas supply requirements for gas dryer models.

ELECTRICAL REQUIREMENTS

Details the necessary electrical service and connections.

GROUNDING

Explains the importance and methods of grounding the dryer for safety.

ELECTRICAL CONNECTIONS

Step-by-step guide for connecting the dryer's electrical supply.

CONNECTING THE INLET HOSE

Instructions for connecting the water inlet hoses.

3-WIRE system connections

Specific wiring instructions for a 3-wire electrical system.

4-WIRE system connections

Specific wiring instructions for a 4-wire electrical system.

FINAL INSTALLATION CHECKLIST

A checklist to ensure all installation steps are completed correctly.

DRYER EXHAUST TIPS

Practical advice for optimizing the dryer's exhaust system.

DOOR REVERSAL

SETTING UP YOUR DRYER FOR THE FIRST TIME

Initial setup procedure after installation, including language and time settings.

Drying a load of laundry

DRYING FOR THE FIRST TIME

BASIC INSTRUCTIONS

Fundamental steps for loading and starting a drying cycle.

USING THE CONTROL PANEL

Detailed explanation of the dryer's control panel interface and functions.

Available cycles

Overview of the different drying cycles available.

Sensor Dry cycles

Explains cycles that automatically determine drying time and level.

Manual Dry cycles

Describes cycles where users manually set the duration.

Steam cycles

Available options

Explains additional settings like dry level, temperature, time, and extras.

Available actions

Describes extra functions like Smart Control, Delay Start, Child Lock.

Settings

Loading the dryer properly

Drying your laundry using the Cycle Selection screen

Step-by-step guide for selecting cycles via the screen.

Using the My Cycle function

Saving a My Cycle

Using the Delay Start function

USING THE RACK DRY

CHECKING THE FILTER

Cleaning the filter

VENT SENSOR

Using your mobile phone

CONFIGURING YOUR DRYERS NETWORK SETTINGS AND CONNECTING TO YOUR NETWORK

Steps to connect the dryer to a Wi-Fi network.

Configuring the IP address settings

Connecting your dryer to the network

Detailed procedure for establishing the Wi-Fi connection.

TURNING ON THE WI-FI NETWORKING FUNCTION OF YOUR DRYER

How to enable the dryer's Wi-Fi capabilities.

HOW TO UPDATE THE SOFTWARE

DOWNLOADING AND RUNNING THE MOBILE APP, SAMSUNG SMART WASHER;DRYER APP

Guide to download and install the companion mobile application.

USING THE MOBILE APP

How to operate the dryer using the mobile application.

Starting a new load

Registering your dryer

Care and cleaning

CONTROL PANEL

TUMBLER

STAINLESS STEEL TUMBLER

DRYER EXTERIOR

DRYER EXHAUST SYSTEM

Troubleshooting

Doesnt run.

Solutions for when the dryer fails to start.

Doesnt heat.

Solutions for when the dryer is not heating.

Doesnt dry.

Solutions for when clothes are not drying properly.

Is noisy.

Troubleshooting steps for unusual dryer noise.

Dries unevenly.

Has an odor.

Shuts off before the load is dry

Lint on clothes

Garments still wrinkled after Wrinkle-Care

Odors remain in clothing after Refresh.

Water drips from the nozzle when Steam-Care starts

Sprayed water is not visible during Steam-Care

INFORMATION CODES

Explains how error codes help diagnose dryer problems.

dF

bE2

FE

2 E

AE

Et

AE4

AE3

AE5

NETWORK SETUP Q&A

Warranty (U.S.A)

Warranty (CANADA)

LIMITED WARRANTY TO ORIGINAL PURCHASER

Details the terms and conditions of the limited warranty for Canadian customers.

Samsung DV457EVGSGR/AA Specifications

General

Brand	Samsung
Model	DV457EVGSGR/AA
Type	Electric Dryer
Capacity	7.5 cu. ft.
Color	Graphite
Dryer Venting	Vented
Energy Star Certified	Yes
Wrinkle Prevention Option	Yes
Moisture Sensor	Yes
Steam Option	Yes
Control Type	Electronic
Display Type	LED
Width	27 inches