Samsung DV457EVGSGR/AA User Manual (English)

Other manuals for Samsung DV457EVGSGR/AA

Questions and Answers:

T
Thomas RiosAug 15, 2025
Why my Samsung DV457EVGSGR/AA Dryer will not start?
- J
  Jennifer BennettAug 15, 2025
  If your Samsung Dryer isn't starting, ensure all wires are correctly connected to their terminals and that the dryer is properly plugged in. Also, check for a blown fuse or tripped circuit breaker. Verify the door switch is functional and the door is fully closed; an error code 3 might indicate a door issue. Confirm the Start/Pause rotary selector dial and the Control Board are working. Inspect the belt for damage or if it's off, and ensure the Belt Cut-off Switch is operating correctly. Finally, check if the drive motor is functional and verify the motor winding resistance: it should be 2.88 ohms between pin #3 and 4, and 3.5 ohms between pin #4 and 5.
B
Brandon BellAug 18, 2025
Why does my Samsung DV457EVGSGR/AA (Gas Model) keep blowing fuses or tripping the circuit breaker?
- J
  Jennifer HowardAug 18, 2025
  If your Samsung gas dryer blows fuses or trips the circuit breaker, it could be due to several reasons. During ignition, the dryer draws a specific amperage; if it's drawing more than usual with the burner on, the issue might be with your house wiring, fuse box, or circuit breaker. Other potential causes include a loose igniter harness shorted to the base, incorrect wiring or a wire shorted to ground, or a drive motor winding shorting to ground. Check these components to resolve the issue.
J
Jeremy GarciaAug 21, 2025
What to do if Samsung DV457EVGSGR/AA motor runs but the tumbler won't turn?
- J
  Jodi BauerAug 21, 2025
  If your Samsung Dryer motor runs but the tumbler won't turn, the belt might be off, broken, or damaged. Alternatively, the idler tension spring could be too weak or stretched, or the idler pulley might be jammed or stuck. Inspect these components to resolve the issue.
S
steven07Aug 25, 2025
Why does my Samsung DV457EVGSGR/AA run a few minutes and then stops?
- R
  Ronald SharpAug 25, 2025
  If your Samsung Dryer runs for a few minutes and then stops, it could be due to lint buildup around the drive motor. Other potential causes include low voltage, a blocked blower impeller in the blower housing, or the drive motor's start switch contacts being stuck closed. Check these areas to troubleshoot the issue.
D
Daniel SmithAug 27, 2025
What to do if my Samsung DV457EVGSGR/AA Dryer will not heat but motor runs?
- R
  rangellisaAug 27, 2025
  If your Samsung Dryer won't heat but the motor is running, check for an open heating element, a hi-limit that trips easily or is open, or a regulating thermostat that trips easily or is open. Also, inspect the membrane switch for being open and check the thermistor.
J
Jacob BurgessAug 30, 2025
How to fix improper drying, wrinkled clothes and long dry time with my Samsung DV457EVGSGR/AA Dryer?
- B
  Benjamin HoustonAug 30, 2025
  If your Samsung dryer is producing wrinkled clothes, or the texture is rough, or the drying time is too long, consider the following: * Make sure the lint filter is clean. * Check for any restrictions in the exhaust system. * Ensure the outside exhaust hood damper door isn't stuck closed. * Verify the exhaust isn't too long, doesn't have too many elbows, and doesn't use flexible ductwork. * Ensure the dryer has adequate intake air. * Check the tumbler speed and belt for slipping. Also, check the blower impeller for obstructions and avoid overloading the dryer. Finally, review clothing labels for fabric content and the selected cycle, and ensure clothes aren't too wet from the washer.
J
joshua23Sep 2, 2025
How to troubleshoot a noisy and vibrating Samsung Dryer?
- B
  Brittany CraigSep 2, 2025
  If your Samsung Dryer is making unusual noises or vibrating, here's what to check: * Thumping: Inspect for loose tumbler baffles, worn or misaligned rear tumbler rollers, an out-of-round tumbler, or a high weld seam on the tumbler. * Ticking: Look for a loose wire harness or an object caught in the blower wheel area. * Scraping: Check the front or rear bulkhead felt seal for being out of position or worn tumbler front bearings. * Roaring: See if the blower wheel is rubbing on the blower housing or if there are bad motor bearings. * Popping or squealing: Inspect for a sticky or frayed belt.
Q
qcohenSep 5, 2025
Why the igniter does not glow in my Samsung DV457EVGSGR/AA Dryer?
- G
  grayemilySep 5, 2025
  If the igniter in your Samsung Dryer does not glow, check for an open flame sensor or an open igniter. Also, look for a shorted booster coil, open wiring, a bad motor switch (neutral supply), or a lack of power from the control (L1 supply).
T
Tim MillerSep 8, 2025
What causes the igniter to glow, but no gas ignition in Samsung DV457EVGSGR/AA?
- D
  deborah21Sep 8, 2025
  If the igniter glows but there is no gas ignition in your Samsung Dryer, check for an open secondary coil or an open holding coil. Also, inspect the wire harness for any opens and ensure the flame sensor is not stuck closed.

Samsung DV457EVGSGR/AA Specifications

General

Brand	Samsung
Model	DV457EVGSGR/AA
Type	Electric Dryer
Capacity	7.5 cu. ft.
Color	Graphite
Dryer Venting	Vented
Energy Star Certified	Yes
Wrinkle Prevention Option	Yes
Moisture Sensor	Yes
Steam Option	Yes
Control Type	Electronic
Display Type	LED
Width	27 inches