Installation
English 13
STEP 5 Level the dishwasher
For FBI (Fully Built-In) models, go to STEP 6 and install the custom panel rst. Then, return
to the current step (STEP 5) and level the dishwasher.
0-60 mm
0-45 mm
45-60 mm
Normal
Tall-kitchen
(Switch to the sub foot)
You can adjust the height of the
dishwasher to level it. Note that in these
steps, the dishwasher is currently inserted
halfway.
1. Use the level to check if the dishwasher
is level.
2. To adjust the front height, use a 22 mm
wrench.
• To lower the height, turn the foot
counter clockwise.
• To raise the height, turn the foot
clockwise.
3. To adjust the rear height, insert the
Torx T20 screwdriver in the bottom
center of the dishwasher.
• To lower the height, turn the
screwdriver clockwise.
• To raise the height, turn the
screwdriver counter clockwise.
4. When levelling is complete, check if the
door opens and closes properly.
DW9000M_DD68-00193B-02_EN.indd 13 2018-04-10 12:58:52
To Next Page
Loading...
