Samsung DW60M9970 Series - FBI (Fully Built-In) Models

Installation
Installation
English20
FBI (Fully Built-In) models
A
1. Insert the supplied rubber skirt (A) into
the 3 holes at the bottom of the door.
(applicable models only)
Ø2
10~12
2. Put the installation template on the
back of the custom panel and x it
temporarily using transparent tape.
Note that the rear of the custom panel
will be attached to the dishwasher door.
CAUTION
• The top end of the custom panel must
be aligned with the top end of the
installation template.
• Use a custom panel between 4 kg and
9 kg.
3. Mark 6 points guided on the installation
template.
B
C
B
C
4. Remove the installation template and
tighten the custom panel xers (B) at
the top with 2 screws (C, Ø4 X 16) as
shown.
DW9000M_DD68-00193B-02_EN.indd 20 2018-04-10  12:58:55