Installation
English 21
FBI (Fully Built-In) models
B
A
30 mm
5. While holding the custom panel, attach
it to the door and insert the custom
panel xers (B) into the corresponding
holes at the top of the door as shown.
6. Push the custom panel downward to
x.
CAUTION
Do not let the custom panel extend
more than 30 mm from the top of the
dishwasher.
7. Cut the rubber skirt (A) using a cutting
knife so that it is aligned with the
front line of the dishwasher, which is
represented as a dashed line.
12345
30˚
8. Refer to the table below and adjust the
spring level by turning the spring screw
with Torx T20 screwdriver on the front
of the dishwasher.
• Adjust the spring level while the door is
approximately opened at 30 degrees.
• The door should hold its position. It
should not fall open.
CAUTION
Do not adjust the spring level while the
door is completely opened.
Recommended spring levels
Level Weight of the custom panel (kg)
Level 1-2 4-5
Level 2-3 5-6
Level 3-4 6-7
Level 4-5 7-9
CAUTION
If the custom panel weighs more than 9 kg, the door may fall open. Custom panels
weighing more than 9 kg are not recommended.
DW9000M_DD68-00193B-02_EN.indd 21 2018-04-10 12:58:55
To Next Page
Loading...
