ENGLISH-15
02 INSTALLATION
Using installation/service mode of ERV wired remote controller
Additional functions of ERV wired remote controller
SEG used
Main menu
Exit
Set, Cancel
Up and down
Left and right
Sub menu
1 2
1. If you want to use the various additional functions for the ERV wired remote controller,
press the Mode and buttons at the same time for more than three seconds.
You will enter the additional function settings, and the main menu is displayed.
2. Refer to the list of additional functions for the ERV wired remote controller on the next
page, and select the desired menu.
Using the / buttons, select a main menu number and press the Away button to enter the sub-menu
setting screen.
Using the
/ buttons, select a sub-menu number and press the Away button to enter data setting
screen.
When you enter the setting stage, the current setting is displayed.
Refer to the chart for data settings.
Using the
/ buttons, select the settings and press the Away button to move to the next setting.
Press the Set button to save the settings and exit to the sub-menu setting screen.
Press the Timer button to exit to normal mode.
• While setting the data, press the Mode or Away button to move the digit of SEG.
• If you press the Timer button while your are setting data, you can exit to the sub-menu setting
stage without saving your changes.
Note
ERV Wired remote controller_MWR_VH12N_IM_EN_05309A-00.indd 15 2016-12-23 오후 6:02:55
To Next Page
Loading...
