Samsung FH18BTA(X) - Setting Option Setup Method

3-2 Setting Option Setup Method
ex) Option No. :
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temp. button simultaneously and
insert the battery again.
3
rd
Make sure the remote control display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
1
2
3
4
5
6
1
2
The default value is .
Otherwise, push the button to .
Every time you push the button, the display panel reads or
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
3
4
5
6
✳ Setting is not required if you must
a value which has a default.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
24121A(1)_1 1/28/05 6:18 AM Page 3-3
Samsung Electronics3-3