Samsung FH18BTA(X) - Page 27

Disassembly and Reassembly
Samsung Electronics4-9
No Parts Procedure Remark
5
6
Stepping Motor
Display PCB
1) Loosen the 4 screws in rear side of Front
Cover assembly as shown in picture.
2) Loosen the 2 screws as shown in picture.
3) Disassemble the Blade and Stepping
Motor assembly and remove the 2 Screws
Stepping Motor.
1) Loosen the 3 screws in rear side of
Front Cover assembly as shown in
picture.
2) Disassemble Display PCB assembly
and Disconnect Wire.
3) Disassemble the Display PCB.
24121A(1)_1 1/28/05 6:18 AM Page 3-14