Installation and Connection
● This appliance is NOT intended for use in a commercial environment.
● Please observe the installation instructions provided and note that this appliance should
only be installed by a qualified technician.
● The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket. The fuse protection must be rated at 16 amps (L or B-type miniature circuit
breakers).
● In case a new socket is need, installation and cable connection must only be done by a
qualified electrician. If the plug is no longer accessible following installation, a pole discon-
necting device must be present on the installation site with a contact gap of at least 3 mm.
● Adapters, multiway strips and extension cords must not be used. Overloading can result in
fire.
● Plug in
When the appliance has been connected for the first time, all segments are lit for a second.
After 3 seconds, 12:00 flashes in the display prompting you to select the clock. Do not
forget to reset the clock when you switch to and from summer or winter.
To Next Page