Samsung Galaxy Prevail LTE - Page 305

Settings 296
● Pairing Bluetooth Devices: Make sure the other devices are set to be discovered. From
Bluetooth settings, tap the device name in “Available devices” and follow the onscreen
instructions.
 Depending on the device, you may be required to enter or accept a passkey.
 If the target device does not appear, tap Scan to search again.
 This setting is available when Bluetooth is enabled.
● Change the Name of a Paired Device: From Bluetooth settings, tap Settings next to a
paired device name, tap Rename, enter a new name, and tap OK.
 Emoji cannot be used in a device name.
 This setting is available when Bluetooth is enabled.
● Cancelling Pairing: From Bluetooth settings, tap Settings next to a paired device name,
and then tap Unpair.
 This setting is available when Bluetooth is enabled.
● Enable Service from Paired Device: From Bluetooth settings, tap Settings next to a paired
device name, and then tap the listing under Profiles.
 If a confirmation prompt appears, follow the onscreen instructions.
 This setting is available when Bluetooth is enabled.
 This setting is available when the paired device is providing a service.
 Tap the ON/OFF switch to turn the option on or off.
● Search for Other Devices: From Bluetooth settings, tap Scan.
 This setting is available when Bluetooth is enabled.
● Set Visibility Timeout: From Bluetooth settings, tap More options > Visibility timeout and
select an option.
 Tap Never timeout to allow your phone always to be discoverable unless you turn off
discoverability.
 This setting is available when Bluetooth is enabled.
● Check Files Received via Bluetooth Transfer: From Bluetooth settings, tap More options >
Received files, and follow the onscreen instructions.