Multimedia 199
3. Tap
Scan
and select the single device name to begin the
connection process to another Wi-Fi Direct compatible device.
– or –
Tap
Multi-connect
➔
Scan
and select all the device names to
begin the connection process to these Wi-Fi Direct compatible
devices.
Note:
The target device must also have Wi-Fi Direct service active and
running before it can be detected by your device.
4. Tap
Done
. The direct connection is then established. Confirm
appears in the Status bar.
5. When prompted to complete the connection, the recipient
should tap
OK
. Your status field now reads “Connected” and
your connected device is listed within the Wi-Fi Direct devices
listing.
6. Each partner (including yourself) must then tap
Accept
to
consent to the new Wi-Fi Direct pairing.
To enable Share shot on Camera:
1. From the Home screen, tap
(
Camera
) ➔
(
Shooting
Mode
) ➔
Share shot
.
2. If you are prompted to activate your Wi-Fi Direct connection,
tap
OK
and follow the activation procedures for Wi-Fi Direct.
To Next Page
Loading...
