25
Notes on Usage
Notes on Usage
Draining water when the product gets wet
• If the product gets wet, make sure to drain water from the
tray eject hole, mouthpiece/microphone (upper/lower) holes,
headset connection terminal, external connection terminal,
and speaker.
• Continued use will present a risk of getting your clothes/bag
wet or make it harder to hear the sound.
• Follow the steps below to drain water.
a
Hold the product rmly and wipe o moisture on the
product surface and back side with dry, clean cloth etc.
b
Shake the product approximately 20 times, rmly holding
it, until there is no more water splattering.
c
Swing the product about 10 times against a dry, clean
cloth etc. to wipe o water remaining in the headset
connection terminal, mouthpiece/microphone, receiver,
speaker, key etc.
d
Wipe o water drained from the product with dry, clean
cloth etc., and dry naturally.
Water, if any, remaining in the product may ooze up after
wiping o.
Do not wipe o water remaining in gaps directly with a
cotton swab etc.
To Next Page
Loading...
