VANGO(VL40)
SAMSUNG HARD DISK DRIVE
3 times per 1 cylinder.
Maintenance Cylinder Check(M/C): Read Maintenance cylinder from the number of 0 to the last.
W
In case of "MC", remark "failure" when error happened in one time.
Media Check
: Read from OD to ID region same as the existing read test function and progress "D/F"
whenever defect occurred.
X
Auto Defect Free: Reading along OD to ID region, progress "D/F" promptly if defect occurred.
Read the next sector if no defect occurred and progress D/F if defect occurred.
When we don't have any more cylinder space for D/F, stop progressing D/F and then remark
defect status for the next 30 defects occurred from the D/F st opping location.
Y
Remark failure:
- If the number of defects are same in OD,MD,ID region
W
remark failure in order of OD > MD > ID.
- If the number of defects are different in OD,MD,ID region
W
remark failure in region have the most defects among OD,MD,ID region
ZZ
continuousness: Continuous scratch more than 15 cylinders
ZZ
divergence: Divergent scratch less than 15 cylinders
Test OK: Remark "Test OK" if no problem occurred when test done.
If it passed due to D/F, remark "Defect free by pass~" and show the corresponding
failure region in the below. At this time, input the code of failure region shown and
the control code 'is a "Defect controlled".
R
Display Read time with checking during Read test,
(Stop reading if expecting read time exceeded +10 when 50 % tested.)
"
""
"
#
##
#$
$$
$
%
%%
%&
&&
&
!
!!
!
& .
To Next Page
Loading...
