Samsung Heba WF8802 Series - Page 26

Removal and Reassembly _ 27
Part Figure Description
HEATER
1. SeparatetheBackCover.
2. SeparatetheConnectionHousing(3).
3. Removethenutholdingtheheaterand
separatetheHeater.
4. RemovetheHeaterfromtheTub.
Caution
 Makesuretoinsert
theHeaterintothe
correct position of
thebracketinside
theTubwhen
reassemblingit.
Otherwise,thereis
adangerofare.
 Makesuretopushitinwardsuntilthe
packingpartcomesintotheTubcompletely
whenreassemblingitsothatthepacking
partiscompletelystucktotheTub.
Fastentheholdingnutwithaforceof5Kgf/
cm2.
Ifthenutisnotfastenedproperly,thereisa
dangerofwaterleaking.
WF-M592NMH-YLP.indb 27 2010-2-22 13:29:55