Samsung HG32NJ470NF - 4-5. White Ratio (Balance) Adjustment

4-5. White Ratio (Balance) Adjustment
Youcanadjustthewhiteratioinfactorymode(1:Calibration,3:White-Balance).1.
Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS, 2.
Component 1 and HDMI 1 modes.
Theoptimalvaluesforeachmodeareconguredbydefault.(RefertoTable1,2)ItvarieswithPanel’ssizeand3.
Specication.
Equipment : CS-210•
Pattern: MIK K-7256 #92 "Flat W/B Pattern" as standard•
Use other Equipment only after comparing the result with •
that of the Master equipment.
Set Aging time : 60min•
Calibration and Manual setting for WB adjustment.•
HDMI : Calibration at #24 Chessboard Pattern Manual adjustment #92 pattern (720p)
COMP : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
CVBS : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (NTSC)
NOTE
IfnishinginHDMImode,adjustmentcoordinateisalmostsameinAVmode.•
White Balance Manual adjustment.•
4-25
4. Troubleshooting