Disassembly & Reassembly
12-4 Samsung Electronics
Part Name Description Description Photo
Digital
Board
① Use the long-nosed pliers to remove the hex nut.
Nut-Hexagon : -,M3/8X32,ZPC(WHT),MBSBD
: The standoffs can easily break if excessive force is applied.
Use extreme caution when removing and replacing.
① Remove 2 standoffs from the DVI connector.
StandOff : M3,L5,Ni PLT,SUM24L,#4-40
② Remove 2 standoffs from the PC connector.
① Remove the screws and cables.
: PWH,B,M3,L10,ZPC(YEL),SWRCH18A
: The 30 pin shield cable should be removed by holding the
two lock ends of the cable, as failing to do so, could damage the
connector.
① After Removing the Top Shield Case.
: Use the two lock holes on either side of the shield case
when removing it.
To Next Page
Loading...
