Samsung HT-C9950W - Connecting the FM Antenna

34 English
Connections
HDMI Auto Detection Function
The product's video output automatically changes to HDMI mode when connected to a TV or other
device with an HDMI cable while the power is on.
Auto Detection is not available if the HDMI cable does not support CEC.
HDMI connection description
- HDMI outputs only a pure digital signal to the TV.
- If your TV does not support HDCP, random noise appears on the screen.
What is the HDCP?
HDCP (High-band width Digital Content Protection) is a system for protecting BD/DVD content outputted via
HDMI from being copied. It provides a secure digital link between a video source (PC, DVD. etc) and a display
device (TV, projector. etc). Content is encrypted at the source device to prevent unauthorized copies from being
made.
CAUTION
The Anynet+ function is supported only when an HDMI Cable is connected to the HDMI OUT of the
product.
•
•
•
!

Connecting the FM Antenna
Connect the FM antenna supplied to the FM ANT Jack.
Slowly move the antenna wire around until you fi nd a location where reception is good, and then
fasten the antenna to a wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
1.
2.
✎

FM Antenna (supplied)
HT-C9950W_XAA_0830.indd 34HT-C9950W_XAA_0830.indd 34 2010-08-30  10:14:122010-08-30  10:14:12