Samsung HT-C9950W - Wireless Network

English 37
02 Connections
Wireless Network
You can connect the home thaeater to a network through a Wireless IP sharer (either a router or modem).
Connect the suppplied wireless LAN adapter to the Wireless LAN Adapter jack on the rear panel of
the product.
- This unit is compatible with the supplied Wireless LAN Adapter.
Set the network options. (See page 49)
NOTE
You must use a wireless IP sharer (router or modem) that supports IEEE 802.11 a/b/g/n. We
recommend using IEEE 802.11n for stable operation of the wireless network.
Wireless LAN, in its nature, may cause interference, depending on the operational conditions (AP
performance, distance, obstacle, interference by other radio devices, etc.).
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
The home theater supports the following wireless security key protocols:
Authentication Mode : WEP, WPAPSK, WPA2PSK
Encryption Type : WEP, AES
To use the AllShare function, you must connect a PC must be connected in the network as
shown in the fi gure above.
The connection can be wired or wireless.
1.
2.
✎




1)
2)


Wireless IP sharer
Wireless LAN Adapter
Networking with PC for
AllShare function
(See pages 75~76)
PC
Broadband
service
HT-C9950W_XAA_0820.indd 37HT-C9950W_XAA_0820.indd 37 2010-08-20  3:46:382010-08-20  3:46:38